HD Tune Pro ID kısmında BB ne demek?

ulpian dedi:

Sizin sorduğunuz BB kodlu hata yani 0xBB, bildirilen düzeltilemez hatalar anlamına geliyor.


HDD ve SSD için S.M.A.R.T. hata listesi full

Kod	Hata
0x1	Raw Read Error Rate
0x2	Throughput Performance
0x3	Spin Up Time
0x4	Start/Stop Count
0x5	Reallocated Sector Count
0x6	Read Channel Margin
0x7	Seek Error Rate
0x8	Seek Time Performance
0x9	Power-On Time Count
0xA	Spin Retry Count
0xB	Recalibration Retries
0xC	Device Power Cycle Count
0xD	Soft Read Error Rate
0x16	Current Helium Level
0x64	Erase or Program Cycles
0x67	Translation Table Rebuild
0xAA	Available Reserved Space
0xAB	SSD Program Fail Count
0xAC	SSD Erase Fail Count
0xAD	SSD Wear Leveling Count
0xAE	Unexpected power loss count
0xAF	Power Loss Protection Failure
0xB0	Erase Fail Count (chip)
0xB1	Wear Range Delta
0xB2	Used Reserved Block Count
0xB3	Used Reserved Block Count Total
0xB4	Unused Reserved Block Count Total
0xB5	Program Fail Count Total or Non-4K Aligned Access Count
0xB6	Erase Fail Count
0xB7	SATA Downshift Error Count or Runtime Bad Block
0xB8	End-to-End error
0xB9	Head Stability
0xBA	Induced Op-Vibration Detection
0xBB	Reported Uncorrectable Errors
0xBC	Command Timeout
0xBD	High Fly Writes
0xBE	Airflow Temperature
0xBF	Mechanical Shock
0xC0	Power off Retract Cycle
0xC1	Load/Unload Cycle Count
0xC2	HDD Temperature
0xC3	Hardware ECC Recovered
0xC4	Reallocation Event Count
0xC5	Current Pending Sector Count
0xC6	Off-Line Uncorrectable Sector Count
0xC7	Ultra ATA CRC Error Count
0xC8	Write Error Rate
0xC9	Soft Read Error Rate
0xCA	Data Address Mark Errors
0xCB	Run Out Cancel
0xCC	Soft ECC Correction
0xCD	Thermal Asperity Rate
0xCE	Flying Height
0xCF	Spin High Current
0xD0	Spin Buzz
0xD1	Offline Seek Performance
0xD2	Vibration During Write
0xD3	Vibration During Write
0xD4	Shock During Write
0xDC	Disk Shift
0xDD	G-Sense Error Rate
0xDE	Loaded Hours
0xDF	Load/Unload Retry Count
0xE0	Load Friction
0xE1	Load Cycle Count
0xE2	Load-in Time
0xE3	Torque Amplification Count
0xE4	Power-off Retract Count
0xE6	GMR Head Amplitude
0xE7	Hard Disk Temperature
0xE8	Endurance Remaining
0xE8	Available Reserved Space
0xE9	Power-On Hours
0xE9	Media Wearout Indicator
0xEA	Average erase count AND Maximum Erase Count
0xEB	Good Block Count AND System(Free) Block Count
0xF0	Head Flying Hours
0xF1	Total LBAs Written
0xF2	Total LBAs Read
0xF3	Total LBAs Written Expanded
0xF4	Total LBAs Read Expanded
0xF9	NAND_Writes_1GiB
0xFA	Read Error Retry Rate
0xFB	Minimum Spares Remaining
0xFC	Newly Added Bad Flash Block
0xFE	Free Fall Protection

Genişletmek için tıkla...