Sizin sorduğunuz BB kodlu hata yani 0xBB, bildirilen düzeltilemez hatalar anlamına geliyor.
HDD ve SSD için S.M.A.R.T. hata listesi full
Kod | Hata |
---|
0x1 | Raw Read Error Rate |
0x2 | Throughput Performance |
0x3 | Spin Up Time |
0x4 | Start/Stop Count |
0x5 | Reallocated Sector Count |
0x6 | Read Channel Margin |
0x7 | Seek Error Rate |
0x8 | Seek Time Performance |
0x9 | Power-On Time Count |
0xA | Spin Retry Count |
0xB | Recalibration Retries |
0xC | Device Power Cycle Count |
0xD | Soft Read Error Rate |
0x16 | Current Helium Level |
0x64 | Erase or Program Cycles |
0x67 | Translation Table Rebuild |
0xAA | Available Reserved Space |
0xAB | SSD Program Fail Count |
0xAC | SSD Erase Fail Count |
0xAD | SSD Wear Leveling Count |
0xAE | Unexpected power loss count |
0xAF | Power Loss Protection Failure |
0xB0 | Erase Fail Count (chip) |
0xB1 | Wear Range Delta |
0xB2 | Used Reserved Block Count |
0xB3 | Used Reserved Block Count Total |
0xB4 | Unused Reserved Block Count Total |
0xB5 | Program Fail Count Total or Non-4K Aligned Access Count |
0xB6 | Erase Fail Count |
0xB7 | SATA Downshift Error Count or Runtime Bad Block |
0xB8 | End-to-End error |
0xB9 | Head Stability |
0xBA | Induced Op-Vibration Detection |
0xBB | Reported Uncorrectable Errors |
0xBC | Command Timeout |
0xBD | High Fly Writes |
0xBE | Airflow Temperature |
0xBF | Mechanical Shock |
0xC0 | Power off Retract Cycle |
0xC1 | Load/Unload Cycle Count |
0xC2 | HDD Temperature |
0xC3 | Hardware ECC Recovered |
0xC4 | Reallocation Event Count |
0xC5 | Current Pending Sector Count |
0xC6 | Off-Line Uncorrectable Sector Count |
0xC7 | Ultra ATA CRC Error Count |
0xC8 | Write Error Rate |
0xC9 | Soft Read Error Rate |
0xCA | Data Address Mark Errors |
0xCB | Run Out Cancel |
0xCC | Soft ECC Correction |
0xCD | Thermal Asperity Rate |
0xCE | Flying Height |
0xCF | Spin High Current |
0xD0 | Spin Buzz |
0xD1 | Offline Seek Performance |
0xD2 | Vibration During Write |
0xD3 | Vibration During Write |
0xD4 | Shock During Write |
0xDC | Disk Shift |
0xDD | G-Sense Error Rate |
0xDE | Loaded Hours |
0xDF | Load/Unload Retry Count |
0xE0 | Load Friction |
0xE1 | Load Cycle Count |
0xE2 | Load-in Time |
0xE3 | Torque Amplification Count |
0xE4 | Power-off Retract Count |
0xE6 | GMR Head Amplitude |
0xE7 | Hard Disk Temperature |
0xE8 | Endurance Remaining |
0xE8 | Available Reserved Space |
0xE9 | Power-On Hours |
0xE9 | Media Wearout Indicator |
0xEA | Average erase count AND Maximum Erase Count |
0xEB | Good Block Count AND System(Free) Block Count |
0xF0 | Head Flying Hours |
0xF1 | Total LBAs Written |
0xF2 | Total LBAs Read |
0xF3 | Total LBAs Written Expanded |
0xF4 | Total LBAs Read Expanded |
0xF9 | NAND_Writes_1GiB |
0xFA | Read Error Retry Rate |
0xFB | Minimum Spares Remaining |
0xFC | Newly Added Bad Flash Block |
0xFE | Free Fall Protection |