Nokia G-010G-Q Flash Dump ve Anakart Fotoğrafları

MTD partitions obtained from kernel command line
Creating 4 MTD partitions on "sflash":
0x000000000000-0x000000080000 : "Boot"
0x000000080000-0x000000200000 : "Config"
0x000000200000-0x000000900000 : "ImageA"
0x000000900000-0x000001000000 : "ImageB"

---------------------------------------------------------------

CIG Version: 3.04.25

U-Boot 2011.12.NA-svn132675 (Sep 20 2019 - 17:02:48)

Board: RTL9601B CPU:100MHz LX:200MHz DDR2:325MHz..
SPI-F: 1x16 MB (plr_flash_info @ 9f0028c0)
[debug] start to init flash_info (1)
[debug] <0> unit size=0x10000, unit count=256
*** Warning - bad CRC, using default environment

*** !!! Check Result: Chk_CRC: 0x0, Chk_Empty: 0x0
Device care eqvid: 3FE47211DEAA, Init serial
Net:   LUNA GMAC
Warning: eth device name has a space!

swcore_init
**************************************
*                                    *
*  KEY -- Enter console terminal     *
*                                    *
**************************************
waiting for your select
do_jffs2_fsload offset 0x80400000 loadaddr=0xbd088000..
get loadbit 0,bootbit 0
Get current Image = ImageB..

--- jffs2_part_info: partition number 3 for device sflash0 (sflash.0)

Loading 'uImage' from  CRAMFS Partition 'imageb' to 0x80400000.

Root Filesystem crc check successfully!


PRODUCT:  sfu
SS  :  noss
DSP :  nodsp
WIFI:  nowifi
XDSL:  nodsl
Software version:  3FE45655BOCK55
## Booting kernel from Legacy Image at 80400000 ...
   Image Name:   Linux Kernel Image
   Created:      2020-05-04   1:25:02 UTC
   Image Type:   MIPS Linux Kernel Image (gzip compressed)
   Data Size:    1315371 Bytes = 1.3 MB
   Load Address: 80000000
   Entry Point:  80000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel ...

Linux version 2.6.30.9-cig-sfu-1 (root@chu-VirtualBox) (gcc version 4.4.6 (Realtek RSDK-1.5.6p2) ) #1 Mon May 4 09:24:55 CST 2020
CPU revision is: 0000dc02
Determined physical RAM map:
 memory: 03800000 @ 00000000 (usable)
Device care eqvid: 3FE47211DEAA
Init serial
User-defined physical RAM map:
 memory: 01f00000 @ 00000000 (usable)
Zone PFN ranges:
  Normal   0x00000000 -> 0x00001f00
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00001f00
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 7874
Kernel command line: console=ttyS0,115200 mem=31M root=/dev/mtdblock3 mtdparts=sflash:512K@0x0(Boot),0x180000@0x80000(Config),7M@0x200000(ImageA),7M@0x900000(ImageB) rootfstype=cramfs hasEeprom=0 5srst=0 eqvid=3FE47211DEAA01
root_dev_setup line 179 root: /dev/mtdblock3
icache: 64kB/32B, dcache: 32kB/32B, scache: 0kB/0B
NR_IRQS:128
PID hash table entries: 128 (order: 7, 512 bytes)
console [ttyS0] enabled
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 28348k/31744k available (2192k kernel code, 3396k reserved, 613k data, 104k init, 0k highmem)
Calibrating delay loop... 97.79 BogoMIPS (lpj=48896)
Mount-cache hash table entries: 512
IMEM section size = 0x3244
net_namespace: 532 bytes
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
Sangoma WANPIPE Router v1.1 (c) 1995-2000 Sangoma Technologies Inc.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
Realtek GPIO Driver for Flash Reload Default
NTFS driver 2.1.29 [Flags: R/W].
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
msgmni has been set to 55
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 49) is a 16550A
loop: module loaded
PPP generic driver version 2.4.2
NET: Registered protocol family 24
===============================================================================
init_luna_nor_spi_map: flash map at 0xbd000000
luna spi probe...
luna SPI FLASH G2 driver version 1.00-II: NOR SPI-F... Generic 3B NOR SPI-F detected... done
master->name sflash
cmd: cmdlinepart
4 cmdlinepart partitions found on MTD device sflash
add luna nor spi partition
MTD partitions obtained from kernel command line
Creating 4 MTD partitions on "sflash":
0x000000000000-0x000000080000 : "Boot"
0x000000080000-0x000000200000 : "Config"
0x000000200000-0x000000900000 : "ImageA"
0x000000900000-0x000001000000 : "ImageB"
===============================================================================
u32 classifier
nf_conntrack version 0.5.0 (496 buckets, 1984 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP cubic registered
Realtek SD2-FastPath v1.00beta_2.4.26-uc0
/proc/FastPath created
Realtek MCast FastPath
/proc/mc_FastPath created
NET: Registered protocol family 17
Bridge firewalling registered
Ebtables v2.0 registered
VFS: Mounted root (cramfs filesystem) readonly on device 31:3.
Freeing unused kernel memory: 104k freed

# num is 10,nothing need to do
ONT>SSP read eqvid :3FE47211DEAA01
Starting Application: 0x00002000, /bin/TimerMgr................Done.
Starting Application: 0x00001000, /bin/LogMgr................Done.
app 0x00007000 stop invalid timer[0]
### Invalid Decimal_Factor, use default 0xdb
### Invalid Settle_Time, use default 0x68
### Invalid P1_Mask, use default 0x5a
Tx has been calibrated!!
Starting Application: 0x00007000, /bin/MiscMgr................Done.
starting to upgrade boot
file[/bootimg/00be_02_01] length=172544
Flash bootload versin is 3.04.25
Upgrading bootload versin is 3.04.25
Upgrading boot is old
Check base image file CRC ... cal_crc (35b0a16a) ori_crc (35b0a16a) Success.
Mount Backup[/dev/mtdblock2] as cramfs...Success.
major ID[0xbe] minor ID[0x2]
cp: can't stat '/mnt/rwdir2/sys.log': No such file or directory
mv: can't create '/mnt/rwdir2/sys.log': Read-only file system
cp: can't stat '/mnt/rwdir2/sys.log': No such file or directory
mv: can't create '/mnt/rwdir2/sys.log': Read-only file system
receive MMR_MSG_SET_ACTIVE_IMAGE_ID
receive MMR_MSG_SET_COMMIT_IMAGE_ID
Starting Application: 0x00003000, /bin/MecMgr................Done.
Starting Application: 0x00004000, /bin/PonMgr................Done.
------>NET open default xml failedVOS_RegisterEventListener:2672, Init event socket 9
vos_OnKernelEvent:2593, Start receving event on socket 9
Starting Application: 0x00009000, /bin/NetMgr................Done.
Starting Application: 0x00005000, /bin/EthMgr................Done.
Laser TX OFF
Starting Application: 0x0000c000, /bin/WebMgr................Done.
Laser TX ON
Preparing stress ...

INFO: ALL APPs are ready.