Upgrading Iomega ix2-200 to Cloud Edition

Hey guys, trying to get the firmware...Unfortunately the Rapidshare link is VERY slow, tried for the last couple of days and barely get above 10kbps and the Megaupload site has been taken down (Thankyou ACTA)

Can someone upload a new link? Many many thanks!

EDIT: Nevermind! New link here: http://www.sendspace.com/file/r0ego5
 
Son düzenleyen: Moderatör:
The disks are 100% the same, will use another USB tomorrow (I have to order some)

Thx for your update

KAR

Tried 4 Different USB stick only 2 of them are blinking,but thats all no files extracted at the USB and not at the disks. Looks like the 320 GB disk are not working.

Does anybody have a ghostimage of the 2 disks, using a ghost image I can restore both disks (320 GB) in the correct state??

Thx,
KAR
 
hi guys,
which usb port are you trying to use?i have a friend that only work with the front usb...is only a guess!

one question...the transmission works okay in ix2-200?

cheers
 
hi,
i have a ix2-200 1Tb (2x500Gb) non-cloud converted to cloud.
i have installed firmware 3.2.3.9273, but i have a problem, if the NAS not correctly shutdown (example: unplug power), the NAS start wrong with white led blinking in any reboot, and cannot access by http, https or SMB... only response ping (ICMP) and SSH.

the solution that i was find is log by SSH and execute: shutdown -h now, when start the NAS again, its start well.

have the same problem somebody?

in firmware 3.1.14 this didn't happen

update: after updating the firmware v3.1.14 to v3.2.3.15290 the problem don't occurred anymore

Regards
 
Son düzenleyen: Moderatör:
hi,
i have a ix2-200 1Tb (2x500Gb) non-cloud converted to cloud.
i have installed firmware 3.2.3.9273, but i have a problem, if the NAS not correctly shutdown (example: unplug power), the NAS start wrong with white led blinking in any reboot, and cannot access by http, https or SMB... only response ping (ICMP) and SSH.

the solution that i was find is log by SSH and execute: shutdown -h now, when start the NAS again, its start well.

have the same problem somebody?

in firmware 3.1.14 this didn't happen

Regards

hi guys,

Some times happen the same with me but if you unpluged the calbe power and press the power button for 15 seconds and then connect the power cable again the NAS start normally.
Works with me....

cheers
 

Geri
Yukarı